Summit Treestands Viper SD Mode D'emploi page 10

5
CLIMBING UP / USE / CLIMBING DOWN
CLIMBING UP WITH YOUR NEW STAND
WARNING
!
At this point IT IS MANDATORY AND REQUIRED
that you attach your FBFAHS to the tree and
remain connected at all times after leaving the
ground.
ALWAYS refer to the written FBFAHS instructions
and videos for proper and safe use of your FBFAHS
before climbing.
1. Following the FBFAHS Instructions, attach the
harness tether to the tether strap. Loop the strap
around the tree to secure it. See figure 15.
2. Your RapidClimb stirrups and bungee heel cord
should be already attached to your treestand. To use,
back your heel into the bungee heel cord (figure 16)
then simply slide your boot under the RapidClimb
stirrup. Make sure that your boot is secure under the
stirrup as shown in figure 17.
3. On all models except the 180 Max Model, hook the
black elastic bungee cord around the seat as shown in
figure 18 to keep it secure while you climb.
4. To begin climbing, raise your seat platform up to
just below waist height and grasp the upright arms
very firmly as shown in figure 19.
On the 180 Max you must sit in the seat and face the tree to climb. DO
NOT sit on the front bar while climbing.
UPRIGHT
ARMS
19
PG 10
15
17
WARNING
!
(CLOSED FRONT STANDS)
16
18
www.summitstands.com
UPRIGHT
ARMS