Installation Of The Blue Switch - Mr Handsfree Blue Switch Plug & Play Manuel D'utilisation

INSTALLATION OF THE BLUE SWITCH

Important!
• Make sure that all the necessary cables, the handsfree unit and/or the external speaker are well
installed before connecting the Blue Switch to the power supply of the car.
• During operation, do not attempt to access the speaker unit and the sockets of the speaker unit.
• For disconnecting the Blue Switch, always disconnect the power supply fi rst.
HEADSET / CARKIT
Please place the unit on the indicated location (see illustration III).
• Make sure the dashboard is clean and free of dust or grease before sticking the Velcro strips!
• Make sure the unit is clean and free of dust or grease before placing the Velcro part on the unit.
• For optimal performance, the microphone should be located at a maximum distance of 50 cm from
the driver's mouth. If possible, the microphone of the Blue Switch needs to be pointing directly to
the driver's mouth.
HANDSFREE UNIT
Search for a location in your car where the handsfree unit fi ts and where it is comfortable for use.
• Make sure that the location in your car where you would like to install your handsfree unit is free
from dust and dirt.
• We recommend mounting the handsfree unit at a less visible position in the car. However, make
sure that the unit can provide good acoustic, by having at least 50 cm distance between the speaker
and the headset / carkit.
• Make sure the speaker is not pointing towards the headset / carkit.
The handsfree unit can be fi xed in 2 ways:
1. Under the dashboard or at any other place in the car using the installation screws.
2. Under the dashboard or at any other place in the car using the double-sided tape.
GB-11