Operation - Omcan MX-IT-0020-F Manuel D'instructions

STARTING UP THE MACHINE
For 1st use strictly follow the following instructions:
• Check that installation has been carried out correctly as indicated in chapter 2;
• Lift the tank's lid (Fig. 35) and pour inside the tank all of the water and other liquids necessary for the
dough;
• Add about 50% of the flour and the other solid ingredients (Fig. 36);
• Close the lid by lowering it up to slightly touching the tank;
• Check before any other operation that the main switch is ON;
• Before switch on, check the voltage of the distribution network by means of switch on of the "NETWORK"
warning light (Fig. 37);
• Press the "START" button to start the machine that will start the work cycle;
• After 2-3 minutes stop the machine by pressing the "STOP" button;
• Lift the lid and insert the remaining flour;
• Close the lid and start the machine that will blend all ingredients, transforming it into a homogeneous
dough;
• A thermal overload protection circuit breaker stops the machine in case of a motor jamming. After removing
its cause, you can reset the protection and restart the machine in few minutes.
• At the end of the cycle, the dough will detach from the tank walls, therefore stop the machine;
• If need be, to slightly modify the characteristics of the dough without stopping the machine, pour in the
ingredients using the opening on the tank protection (Fig. 38).
• Before lifting the protection and removing the dough to be placed on the work bench, pull the plug out of
the socket.
MACHINE WITH LIFTABLE HEAD AND REMOVABLE BOWL
Machines with liftable head and removable bowl, though basically working the same as the fixed head and
bowl versions, differentiate themselves because of what they can offer at the end of each work cycle:
• Simplifying the removal of dough from the mixer.
• Saving time in the cleaning phase.
For machine use proceed as described in paragraph 5.1 and at the end of each cycle complete these steps
(Fig. No.39):
• After stopping the machine and unplugging the power supply cable, lift the bowl guard completely.
• Rotate the release knob until the head is unlocked.
• Lift head using the piston below it.
• Rotate the disc clockwise to unlock the bowl.
• Lift and remove the bowl, then remove the mixture.
Once the machine has been emptied, re-assemble the bowl making sure the four pins below are correctly
inserted into the holes in the disc, then rotate it counter clockwise (Fig. No. 40). Reposition the head
horizontally by pushing it to lower it progressively. Rotate the release knob to lock it into position.
9

Operation