KRESS KUS10P Mode D'emploi page 10

grinder motor or break the disc.
When cutting, only cut in the opposite direction to the
disc rotation. If you cut in the same direction as the
disc rotation the disc may push itself out of the cut
slot.
When cutting very hard material best results can be
achieved with a diamond disc.
When using a diamond disc it will become very hot. If
this happens you will see a full ring of sparks around
the rotating disc. Stop cutting and allow to cool at no
load speed for 2-3 minutes.
Always ensure the workpiece is firmly held or clamped
to prevent movement.
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional lubrication or
maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
If the supply cord is damaged, it must be replaced
by the manufacturer, its service agent or similarly
10
qualified persons in order to avoid a hazard.
EN
ENVIRONMENTAL
PROTECTION
Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
PLUG
REPLACEMENT(ONLY
FOR REWIRABLE PLUG
OF UK & IRELAND)
If you need to replace the fitted plug then follow the
instructions below.
IMPORTANT
The wires in the mains lead are colored in accordance
with the following code:
BLUE =NEUTRAL
Brown = Live
As the colors of the wires in the mains lead of this
appliance may not correspond with the colored
markings identifying the terminals in your plug, proceed
as follows. The wire which is colored blue must be
connected to the terminal which is marked with N. The
wire which is colored brown must be connected to the
terminal which is marked with L.
Warning!
Never connect live or neutral wires to the earth terminal
of the plug. Only fit an approved 13ABS1363/A plug
and the correct rated fuse.
Note: If a moulded plug is fitted and has to be removed
take great care in disposing of the plug and severed
cable, it must be destroyed to prevent engaging into a
socket
Connect
Blue to N
(neutral)
Outer sleeve
firmly clamped
DECLARATION OF
CONFORMITY
We,
Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
Declare that the product
Description Angle Grinder
Type KUS10P KUS05P (S10P/S05P-designation
of machinery, representative of Angle Grinder)
Function peripheral and lateral grinding
Complies with the following Directives:
2006/42/EC
2011/65/EU&(EU)2015/863
2014/30/EU
Standards conform to
EN 55014-1
EN 55014-2
EN IEC 61000-3-2
EN 61000-3-3
EN 60745-1
EN 60745-2-3
The person authorized to compile the technical file,
Name Marcel Filz
Address Positec Germany GmbH
Grüner Weg 10, 50825 Cologne, Germany
2020/05/25
Allen Ding
Deputy Chief Engineer, Testing & Certification
Positec Technology (China) Co., Ltd
18, Dongwang Road, Suzhou Industrial
Park, Jiangsu 215123, P. R. China
13 Amp fuse approved
to BS1362
Brown L (live)
Cable grip