Connections To The Board - AERMEC VMF-E19 Manuel D'utilisation Et D'installation

CONNECTIONS TO THE BOARD

• The installation of the VMF-E19/E19I kit
requires that the standard control board
is removed from the fancoil.
• Mount the thermostat housing to the
side of the fan coil units, on the connec-
tions that were of the control board.
• Remove the cover of the thermostat
housing.
•WARNING: make an earth connection for
the thermostat board.
DANGER: it is compulsory to tighten the
screw on the side of the fan coil, as this is
what allows the earth connection of the
entire system.
• Connect the power supply cables.
Warning: respect the L and N polarities.
• Connect the electric cables of the electric
motor. Respect the speed sequence: if
the motor has 4 or more speeds, choose
the 3 required.
• Connect the electric cables of the air
temperature probe (SA).
• Connect the electric cables of the water
temperature probe (SW).
• Connect the electric cables of the
secondary water temperature probe
(SW1) (in 4-pipe hydronic systems).
• Connect the cables for the external
contact (if envisaged).
• Connect the cables for the presence
sensor (if envisaged).
• Connect the cables for the microswitch
(if envisaged).
• Connect the mains and RS485 power
supply cables (if connected to the mains).
• Connect the TTL mains cables (if
connected to the mains).
• Connect the cables of the control panel
(if envisaged).
• Check all the connections and relative
cables are well fixed.
• Arrange the cables so there is no risk of
them being cut, crushed, jerked, scraped,
or generally damaged.
• Check the board fuse is undamaged and
possesses the necessary features.
• Close the box with the cover.
• Fix the power supply cables and valve
cables using the cable clamp.
WARNING: Keep separate electrical
connections from water connec-
tions. Water connections and drain
should be on the side opposite of
the electrical connections.
DANGER: it is compulsory to tighten the screw on the side of the fan coil, as this is what allows
the earth connection of the entire system.
Installation only for VMF-E19
AVMFE19LJ 2201 - 5779300_06
41