Publicité
Les langues disponibles
Les langues disponibles
CAUTION: Lines coasts after turn off.
Do not use under wet conditions.
CAUTION: Inspect area to be trimmed and remove any wire,
cord, or string-like objects which could become entangled in
the rotating line or spool. Be particularly careful to avoid any
wire which might be bent outwardly into the path of the tool,
such as barbs at the base of a chain link fence.
Proper Cutting Stance
Weight should be balanced with both feet on
solid ground.
Basic Cutting Procedure
Slowly swing trimmer side-to-side as shown.
To convert for maintenance edging, turn off the tool. Holding
the trimmer with one hand by the auxiliary handle, grasp
the collar and push in the direction of arrow and rotate the
trimmer head until it stops (half turn), release your hand,
(rotate clockwise when viewed from the switch end). The tool
is locked in the edger position. Rotate the wire edge guide
forward and down into place before edging.
To operated as a maintenance edger, position trimmer
above sidewalk as shown.
Return to trimming position by turning the tool off, push in
direction of arrow and rotating the trimmer head counter
clockwise until it stops. When using the tool in the trimmer
mode you may choose to fold the wire edge guide out of the
way.
WARNING: Do not trim near electrical wires.
OPERATING
Cutting Instructions
LINE FEEDING
Your trimmer uses .065‖ (1.65mm) diameter nylon line to cut
grass and weeds quickly and easily. In time, the tip of the
nylon line will become worn and the auto feed mechanism
will automatically feed and trim a fresh length of line. The
cutting line will wear faster if the cutting is done along
sidewalks or other abrasive surfaces or heavier weeds are
being cut. The line will extend approximately ¼ in. with each
stop and start of the switch trigger until the line reaches the
length of the grass deflector blade. Do not bump unit on
ground in attempt to feed line or for any other purpose.
If your trimmer line hits sharp or abrasive objects, such as
stones, metal pieces, or concrete, the trimmer line can be
cut too short to continue trimming. In this case, you can
manually extend the line:
1.
2.
3.
4.
5.
Line-Feeding Button
4
WARNING: Do not allow familiarity with this type of
product to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
serious injury.
Do not operate a string trimmer in a tree, on a ladder, or
on a scaffold; this is extremely dangerous.
Wear non-slip gloves for maximum grip and protection.
REMOVE THE BATTERY PACK.
Press the line-feeding button with one hand while pulling
the line out with the other.
Press the button repeatedly to release line to the
proper length. Each press of the button will release
approximately 1/4 inch of line. (Note: Release only
enough line to extend just beyond the blade. If too much
line is released, the blade will be unable to cut it to the
correct working length and it may become tangled on
the rotating shaft.)
Install the battery pack.
Restart the trimmer and return to normal operation.
Line-Feeding
Button
Pull
Publicité
