Télécharger Imprimer la page

EarthWise ST00113 Manuel De L'utilisateur page 5

Publicité

Les langues disponibles

Les langues disponibles

TRIMMING INSTRUCTIONS
Angle unit as shown. (Fig. 1)
Slowly swing trimmer side to side as shown. (Fig. 2)
To convert for maintenance edging, turn off the tool. Hold-
ing the trimmer with one hand by the auxiliary handle,
grasp the collar and push in the direction of arrow and ro-
tate the trimmer head until it stops (half turn), release your
hand, (rotate clockwise when viewed from the switch end).
The tool is locked in the edger position. (Fig. 3)
Rotate the wire edge guide forward and down into place
before edging.
To operate as a maintenance edger, position trimmer
above sidewalk as shown. (Fig. 4)
Return to trimming position by turning the tool off, push in
direction of arrow and rotate the trimmer head counter
clockwise until it stops. When using the tool in the trimmer
mode you may choose to fold the wire edge guide up out
of the way.
REPLACING SPOOL / CLEARING JAMS AND TANGLED
LINES
From time to time, especially when cutting thick or stocky
weeds, the line feeding hub may become clogged with sap or
other material and the line will become jammed as a result.
To clear the jam, follow these steps.
- Turn off the trimmer and unplug from power source.
- Press the release tabs on the line spool retainer and remove
the cover by pulling it straight off.
- Lift the spool of nylon line out of the hub and clear any bro-
ken line or cutting debris from the spool area.
- In case of jams and tangled line, unwrap about one foot
(30cm) of line to ensure that it is undamaged. If it is OK, re-
wind it and insert the line ends through the eyelets in the
spool hub.
- Press the spool down GENTLY and rotate it until you feel it
drop into place. (When in place, the spool will freely turn a
few degrees left and right.)
- Snap the spool retainer back on, insert the cord into the
outlet and turn the tool on. In a few seconds or less you'll
hear the line being cut automatically to the proper length.
OPERATING
CUTTING INSTRUCTIONS
Fig. 3
SPOOL
RETAINER
SPOOL
SLOTS
5
Fig. 1
Fig. 4
TABS
SPOOL
CARRIER
Fig. 2

Publicité

loading