Beta 1760/RMS Mode D'emploi page 37

DC current measurement
1 Insert.the.black.test.lead.banana.plug.into.the.negative.(COM).jack.
2 For.current.measurements.up.to.110µA.DC,.set.the.function.switch.to.the.uA.position.and.insert.
the.red.test.lead.banana.plug.into.the.(µA).jack.
3 For.current.measurements.up.to.110mA.DC,.set.the.function.switch.to.the.mA.range.and.insert.
the.red.test.lead.banana.plug.into.the.(mA).jack.
4 For.current.measurements.up.to.10A.DC,.set.the.function.switch.to.the.A.position.and.insert.the.
red.test.lead.banana.plug.into.the.10A.jack.
5 Press.the.AC/DC.button.until."DC".appears.in.the.display.
6 Remove.power.from.the.circuit.under.test,.then.open.up.the.circuit.at.the.point.where.you.wish.
to.measure.current.
7 Touch.the.black.test.probe.tip.to.the.negative.side.of.the.circuit..Touch.the.red.test.probe.tip.to.
the.positive.side.of.the.circuit.
8 Apply.power.to.the.circuit.
9 Read.the.current.in.the.display..The.display.will.indicate.the.proper.decimal.point,.value.and.
symbol.
7