Handicare Coral Mode D'emploi page 10

English
A
B
8
8. Pos A (2x):
- Fig 8A: Position the fork of the tool around the
pocket. Make sure the tip of the fork is between
the seat and the base plate.
- Fig 8B: Gently push/slide the tool downward
between both parts until the clicker unlocks.
10
10. Pos F (2x):
- Position the tool with the tip of the fork
between the seat and the base plate
(at approximately 5cm/2" from the front
corner of the seat).
- Press the tool gently between the seat
and the base plate to unlock the clicker.
12
10
9
9. Pos B-E (2x);
- Fig 9A: Place the wedge end in the pocket by sliding along the
back of the pocket. Tip of the wedge end touches the tip of the
clicker. Tool and base plate are angled.
- Fig 9B: Press down the tool toward the base plate, while lifting
the base plate, until the clicker unlocks.
11
11. Pull the base plate upward over the legs.
Keep the base plate horizontal while pulling.
12. Pull the frame of the backrest
and the legs off the seat.
The arm supports can be
detached and replaced.
A B
M A N U A L