EUROM DryBest 30 Wifi Manuel D'utilisation page 23

off (but the plug is in the socket, but you've not pressed the ON/OFF button!), you
will set the start time. Press a couple of times on the Timer button to set the
number of hours after which you'd like the device to come on.
Press the Timer button on a working device and you will set the stop time. Press a
couple of times on the Timer button to set the number of hours after which you'd
like the device to go off.
Both displays will show the set number of hours. Every time you press the Timer
button, one hour will be added (set from 1 to 24 hours). You can cancel the timer
setting by setting the time to 0 (after 24, you will see 0). The set time will be
'forgotten' if you manually switch off the device, but will remain in the memory if
the device stops due to the water tank being full or during the defrost process.
4. [SPEED] button
Pressing on the fan speed button changes the fan speed from high to low and back
again. The light indicates which speed is set.
5. [OK]-indication light
Light comes on when the set air humidity has been achieved.
6. [DEF]-indication light
When the device is working at a low temperature, the evaporator may freeze. This
also impacts upon the dehumidifying process. In this case, the device will
automatically stop working to defrost (the fan will continue to work at high speed).
The DEF 'defrost' light will come on.
The device checks for freezing of the evaporator.
The defrosting process takes around 10 minutes and the compressor can be
switched off for around 45 minutes for the defrosting process.
7. [Full]-indication light
When the water tank is full, the device will switch off automatically. The indicator
light FULL 'water tank full' will start to light up and there will be a beep (15 times)
to inform the user that the tank needs to be emptied.
To stop the beeping, any button can be pressed.
To empty the tank, place the fingers of both hands in the handle openings on the
left and right of the device and pull the water tank out from the device gently and
in an upright position. Once you have emptied it, place it back in the same position.
After 3 minutes, the device will restart.
When you replace the water tank, you must replace the short, pre-shaped hose
(which is supplied attached to the rear of the device) and lead this through the
channel opening in the water tank. NB: this is important otherwise water damage
may occur!
23