1
Instrument identification
The nameplate is glued to the bottom of the instrument. The supply voltage that is connected must correspond to the
voltage specified on the nameplate.
H
All necessary settings are described in these Operating Instructions. If any difficulties should still arise dur-
ing start-up, you are asked not to carry out any unauthorized manipulations on the unit. You could endanger
your rights under the instrument warranty! Please contact the nearest subsidiary or the head office.
Please read these operating instructions carefully before commissioning the instrument. Keep the manual in
a place that is accessible to all users at all times. Please assist us to improve these operating instructions,
where necessary.
Delivery package
1 seal
1 mounting frame
1 Operating Instructions
4