Contimac Plasma Cutter 85A Mode D'emploi page 30

Visually check the tailpipe's internal hole.
Tailpipe
Check for damage and wear on the surface and inside
the diffuser.
Check that the fumes' exhausts are not obstructed.
Diffuser
Visually check the electrode's internal hole.
Electrode
ERROR ICONS
Error codes appear whenever a problem is detected. These are classified by 2 digits codes
(Error type + error code) referring to the table below.
Only the error code with the highest priority appears on the screen.
Communication
Informs the user that an error has occured in the internal bus.
Warning
The machine keeps functioning. The user must interact with the machine to rectify the fault.
Thermal
The heat sink's temperature is outside the acceptable operating range.
Disruption
The machine block when starting or the cut is interrupted because a fault has occurred. The fault must be rectified and the
machine must be restarted.
Air
Faulty air supply Air supply unplugged or insufficient air pressure.
Shroud
The consumables are not tightened properly. The air supply must be cut off, the consumables reinstalled and the device restar-
ted.
Serious
The product requires a technical intervention.
Error type
1 - Température
30
PLASMA CUTTER 85A / 125A
Error
Signification
code
1 At least one tempature sensor not detected
2
Secondary thermal protection
3 Low secondary thermal protection
4 Primary thermal protection
5 Below ambient temperature <-20°C
Replace the tailpipe if the inner diameter is enlarged
or distorted.
OK NOK
Replace the diffuser if the surface is damaged or
worn, or if fume exhausts are obstructed.
OK
NOK
Replace electrode when the insert is used (removal of
1.5 mm).
NOK
OK
Logo
One of the thermal protections in unplugged.
Have a qualified technician check it.
The internal temperature has become exces-
sive.
Keep the machine's supply on to enable
cooling until protection cancellation.
The room temperature prevents the machine
from operating properly. Move it in a warmer
area.
EN
Cause-Solution