Carat T Serie Manuel D'utilisation page 44

Error message / error Possible cause
The cutting blade is oxide- The cutting blade is
coated overheating, too little
cooling water
Lateral friction in the cut
Cracks on steel core; The cutting blade is too
eccentrical wear of the hard
cutting blade
Motor shaft bearing
STEPS AFTER TROUBLESHOOTING
After completion of the troubleshooting and before switching on, follow the following steps:
1. Check for tightness all threaded joints previously detached.
2. Check proper installation of all previously removed protective devices and covers.
3. Make sure that all tools, materials and other equipment have been removed from the working zone.
4. Clean the working zone and remove any spilled substances such as liquids, processing materials or similar.
5. Make sure that all safety devices of the machine function properly.
86
Troubleshooting Personnel
Check the cooling water Operating personnel
Lower the feed rate, pull the
material slowly
Use a softer cutting blade Operating personnel
Replace the motor shaft
bearing
WIRING DIAGRAM - T-3510 - 230V
87