Publicité
Les langues disponibles
Les langues disponibles
4.0 Use
Starting Operation
► Observe correct mains voltage! The voltage of
the power source must match the voltage specifi ed
on the type plate of the machine. Power tools mar-
ked with 230V can also be operated with 220 V.
4.1 Handle height adjuster (F)
► The handle height adjuster (3) may be used to set a
comfortable working height.
By pulling the locking pin (3), the height/angle of
the handle may be adjusted in 5 stages.
4.1.1 Cable support Figure A.a
The swivelling cable outrigger (21) hang into the
cable holder support (L) on the left or (R) on the right
as required. Insert the power cable through the turns
at the end of the cable holder to keep it away from
the grinding area.
4.2 Switching On/Off - application (G)
1. Move the handle to the working position via the
handle height adjuster (3). (F)
2. Tilt the machine (G) to prevent uncontrolled milling
3. Hold the safety switch (12) pressed.
4. Switch on the machine with one of the two levers
(1) on the underside of the grip.
5. Release the switch (12) again. (G)
6. Set down the machine carefully
4.3 Swivel motor (H)
► For optimal edge processing, the motor may be
swivelled to the right or to the left.
-
Loosen the star-grip screw (8). Loosen the t-screw
(9) and turn the motor in the desired direction.
-
Tighten the star-grip screw (8) again and tighten
the t-screw (9). Turn the hood (5) to the corres ponding
position so that the fl ap (14) is located on the outside.
(see item 5)
(H) a centre, for surface processing b/c right/left for
edge processing
4.4 Slide fl ap / working at a wall (I)
► To work easier at edges, the hood of the machine
features a sliding fl ap (14).
For edge processing, the fl ap (14) must be turned
according to item 4.3 in the correct direction. The fl ap
is able to be slid forward after opening both of the
clamping screws.
This allows the edge of the wall to be milled.
5.0 Ending the work
► After ending the work and when leaving the machi
ne, the mains plug-in must always be removed
from the power outlet.
6.0 Maintenance
6.1 Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean.
The machine must then be sent to an after-sales Ser-
vice agent. Addresses are listed in the Section "After-
sales service and customer assistance".
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specifi ed on the
type plate of the machine.
6.2 Spare parts
Spare parts can be found on the internet at:
http://webcatalog.wolff -tools.com
EN
19
Publicité
