Maintenance Instructions; Procedures In The Event Of Faults - Calira LG 412-DS/IU Mode D'emploi

)
setting of the timer, the process switches to holding charge at a constant
13.8 V.
Note
In parallel operation, the current drawn up by electrical equipment should be
less than the maximum charging current of 12 A. This is the only way to
ensure that the battery is being charged even though consumers are being
supplied.

Maintenance instructions

)
Clean the device and the ventilation slots with a dry, lint-free cloth.
The device is maintenance-free. However, if any faults do occur, please
proceed according to the following table:

Procedures in the event of faults

Fault Action
The battery is not Check the battery connection, ensuring correct polarity.
being charged. Unplug the mains plug of the device and reinsert it.
(see
also thermal switch)
The voltage of the Start the motor and let it run for approx. 30 seconds.
battery has Battery voltage rises above 1.5 volt. The charging
dropped below process starts automatically.
1.5 volt.
The thermal Wait for a few minutes. When the device has cooled
switch was down, it switches itself back on automatically.
triggered.
None of the faults Please contact the manufacturer:
described here Trautmann GmbH & Co. KG
seems to apply. CALIRA-Apparatebau
But the device still Lerchenfeldstr. 9
does not work. D-87600 Kaufbeuren
Internet: www.calira.de
e-mail: info@calira.de
24
Lerchenfeldstr. 9 87600 Kaufbeuren Tel.: +49 (0)8341 9764-0 Fax: +49 (0)8341 67806
"#$ % &'(
/
/