Publicité
Les langues disponibles
Les langues disponibles
Operations:
FILLING THE CLEAN WATER TANK
1
Locate the
Clean Water Tank
The CLEAN WATER TANK
Clean
is the top tank located on
Water
the front of the machine.
Tank
Dirty
Water
Tank
3
Fill the Clean
Water Tank
Turn the CLEAN WATER
TANK upside down.
Unscrew the CLEAN
WATER CAP by turning
counter clockwise.
Remove CLEAN WATER
CAP from the tank and
set aside.
4
Add Cleaning Solution
Fill the tank with HOT tap water
until it reaches the "Fill" line. Add
Rug Doctor All-In-One Cleaning
Solution as directed.
(CLEAN WATER TANK holds
approximately 1 gallon of water.)
Screw the cap back onto the CLEAN WATER
TANK by turning clockwise until completely
tightened.
10
F L E X C L E A N® A L L - I N - O N E F L O O R C L E A N E R
2
Remove the
Clean Water Tank
Push the CLEAN WATER TANK
RELEASE BUTTON and lift the
CLEAN WATER TANK in an
outward motion.
REMEMBER
Always use Rug Doctor cleaning solutions.
Other cleaning solutions may harm the
machine and void the machine warranty.
Fill with hot tap water.
DO NOT USE BOILING WATER! DO NOT
HEAT WATER OR TANK IN MICROWAVE!
5
6
Place the Clean
Now
Water Tank
You Are
Ready
Turn CLEAN
To Clean
WATER TANK
right side
up. Securely
place onto the
machine. You
will hear a "click"
sound when the
tank is locked
into place.
|
U s e r M a n u a l
Operations:
cleaning your carpet
IMPORTANT CLEANING TIP:
Vacuum area with dry vacuum cleaner thoroughly before deep cleaning.
Before plugging in machine, check the POWER SWITCH to make sure it is in
CAUTION
the "off" position.
1
Attach Carpet Nozzle
If the CARPET NOZZLE is not attached:
1. Align the nozzle tabs with the slots in the base of
the machine.
2. Rotate NOZZLE
3
toward machine
2
3. Latch the
NOZZLE by
pressing down
on the top of the
nozzle until you
hear a "click."
1
3
Plug In The Machine
Unwrap the POWER CORD
and insert plug into a properly
grounded outlet.
5
Turn Machine On
Push the POWER SWITCH to
"FLOOR CLEANING" position.
7
Cleaning Your Carpets
Press the SOAP & SCRUB TRIGGER
to apply solution.
Press
Make 2 wet passes. (1 forward,
Soap &
1 back) over each area.
Spray
Trigger
* For heavily soiled areas, make
up to 4 wet passes
Release SOAP & SCRUB TRIGGER approximately 6
inches from stop point to ensure solution is removed.
r u g d o c t o r . c o m
|
1 - 8 0 0 - 7 8 4 - 3 6 2 8
2
Select
Cleaning
Mode
Turn the FLOW
CONTROL DIAL to
the DEEP CLEAN or
QUICK DRY setting
based on desired
cleaning. Refer to
"Flow Control Dial"
instructions on PG 9.
4
Position The Machine
Position the MACHINE onto the
desired area to clean.
6
Release The Handle
Step on the HANDLE RELEASE
PEDAL to pull back/release the
MAIN HANDLE.
Handle
Release
Pedal
8
Leave The Machine On
For 15 Seconds
Leave the machine on for 15 seconds
after cleaning to allow for all of the
dirty solution to be collected into
the DIRTY WATER TANK.
11
Publicité
