Publicité
Les langues disponibles
Les langues disponibles
Build year: xx/xxxx
EN354:2010
0158
Fabr.No.: xxxxxxxxxx
Length: 0,57m
4. Maintenance and Storage
After work ends, clean the lanyard, dry it and store in a dry, well-ventilated dark room.
•
While being transported the lanyard must be kept in a suitable transport container (e.g. equipment bag or
•
equipment box.
Avoid contact with oils or greases. If unavoidable, clean as soon as possible with fine detergent and ample
•
water (40°C). Always dry naturally, never near fire or other heat sources.
For questions about disinfecting the belt shock absorber, please contact the manufacturer.
•
Attention: Strictly follow the cleaning rules!!
5. Materials Information
The lanyard is made of the following materials.
Webbing made of polyamide, karabiner hook made of aluminium, Oval ring made of stainless steel
6. Operational Lifetime
Operational lifetime depends on the particular conditions of use. According to experiences today, one can
assume an operational lifetime of 8 years for the lanyard under normal operating conditions. The build year of
the lanyard is given on the type label.
7. Inspection
Prior to start of work, inspect the belt shock absorber and karabiner hook for wear or damages. Check the
•
function of the karabiner hook. Check label for legibility.
Should there be any doubts about the safety of the systems or its components, they must be replaced
•
immediately. This must be done by the manufacturer or a trained person.
The inspection prior to use can be omitted for certain equipment parts intended for emergencies if they
•
were packed or sealed by a trained person.
As needed, but at least one a year, have an inspection done by the manufacturer or a trained person.
•
Attention: Damaged lanyards may not be used.
Systems subjected to fall must be taken out of services and sent back to the manufacturer or an authorised
•
repair show for maintenance and a new inspection.
The safety of the user is dependent on the effectiveness and durability of the equipment. For this the
•
regular inspection of the equipment is an absolute necessity.
Attention:
No modifications or additions may be made to the product without the prior
written consent of the manufacturer.
Repairs may only be carried out by the manufacturer or a repair shop authorised
by the manufacturer in compliance with the procedures specified by the
manufacturer.
A set of use instructions/inspection log book is delivered with every lanyard. This must be kept with the
equipment. The Declaration of Conformity can be downloaded from the website www.mittelmann.com. You
absolutely must follow the use instructions for the products that are used with the lanyard as well as the
specifically applicable accident protection regulations.
Notified agency involved:
Stand: 21.04.2021
Month/Year of Manufacture
Number and year of the document matching the equipment
ID number of the notified testing agency
Serial number of the lanyards
Length of the lanyard
DEKRA Testing and Certification GmbH
Dinnendahlstraße 9, 44809 Bochum
0158
Publicité
