Inserting / Changing Batteries; Use - MAXXMEE QJ-J Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Body analysis scales
Take the batteries out of the device
when they are dead or if you will not
be using the device for a prolonged
period. This will prevent any damage
caused by leaks.
Remove dead batteries from the
device immediately.
Batteries must not be recharged or
reactivated in any way, disassembled,
thrown into a fi re, immersed in liquids
or short-circuited.
Protect the device from heat, naked
fl ames, direct sunlight, extreme tem-
peratures, persistent moisture and
impacts.
Never jump on the device so that you
do not damage it.
INSERTING / CHANGING
BATTERIES
Please Note!
Before inserting the batteries, check
whether the contacts in the device
and on the batteries are clean, and
clean them if necessary.
Use only the battery type specifi ed in
the technical data.
Always replace all batteries together.
Never use batteries of different types
or brands, or batteries with different
capacities.
If Lo appears on the display, the
batteries are too weak and need
to be replaced. Two 1.5 V batter-
ies of the AAA type are required.
1. Open the battery compartment on
the bottom of the scales by pushing
the locking lug towards the battery
compartment and removing the bat-
tery compartment cover.
2. Take the used batteries out of the
battery compartment.
3. Insert two new 1.5 V batteries, AAA
type. Pay attention to the correct
polarity (+ / –).
4. Close the battery compartment. The
battery compartment cover must
engage audibly.

USE

Please Note!
Always place the device on a dry, fl at
and solid surface. Uneven fl oors or soft
surfaces, such as long pile carpets,
may distort the measurement result.
The device should only be used in
closed indoor rooms with a tem-
perate climate. When the device
is brought from a cold room into a
warm room, condensation can form.
Allow the device to warm back up to
room temperature before it is used.
Before initial use insert batteries (see the
"Inserting / Changing Batteries" chapter).
Good to know
Weigh yourself without any clothing
and barefoot. To make it easier to
compare results, it is advisable to al-
ways weigh yourself at the same time
(preferably in the evening, before
eating) and under the same circum-
stances.
The measured values may be distort-
ed if you measure yourself immedi-
ately after doing sport or you have
not eaten and / or drunk enough over
the day.
Stand on the contact areas during
weighing. The scales can only work
properly if you place yourself correct-
ly on the contact areas.
EN
13

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

00272

Table des Matières