EarthWise QI-JY-1300 Manuel De L'utilisateur page 11

Before carrying out maintenance operations, disconnect power supply.
Regular cleaning and maintenance of your snow thrower
will ensure efficiency and prolong the life of the product.
After each use, take apart and clean out the ice and
debris from the ventilator and its slots, the auger and
the housing.
Only use a cloth soaked with hot water and a soft brush
to clean the snow thrower. Never wet or spray water on
the machine!
Do not use detergents or solvents as these could cause
irreparable damage to the snow thrower. Chemicals can
destroy the plastic parts.
To protect the snow thrower from corrosion when storing
for long periods, lightly oil the metal parts.
Store the appliance in a dry area out of reach of children.
For the user's safety, worn or damaged parts must be
replaced. Replace with original replacement parts only.
Parts from another snow thrower may not fit properly
causing an unsafe situation.
Changing the belt (Fig. 7, 8)
The drive belts (14) and (21) need to be replaced when
worn.
Drive Belt (14)

Remove screws and take off the cover (18).

Remove screw, washer (16), pulley frame (15), and
the belt (14) from the pulleys.

Install the new belt in the same groove as the old
one.

Replace the screw, washer (16) and pulley frame
(15).

Replace the cover (18) and secure with screws.
Drive Belt (21) small

Remove screws and take off the cover (18).

Loosen the nut and take the pulley (20) and the belt
(21) off of the shaft.

Install new belt (21) with the pulley onto the shaft.

Secure with the nut.

Replace the cover (18) and secure with screws.
MAINTENANCE AND STORAGE
11
7
8