Publicité
Les langues disponibles
Les langues disponibles
Glass Installation
Wear eye protection during the assembly of this unit. Check all glass and parts for damage. Replace
any damaged parts prior to continuing the installation. Do not assemble this unit with any damaged
parts. If you should happen to break a glass panel, it must only be replaced with ceramic glass.
1. The door panel has had the latch assembly and hinges installed at the factory. Remove the bottom
hinge leaving the glued on plate in position.
2. Place the lower hinge in the hole in the fi re bowl, with the washer under it.
3. Insert the upper hinge into the hole at the top of the door opening. Slide the glass door panel into the
bottom hinge.
4. Hold the door panel in the closed position to allow access to the hinge screws.
5. Maintaining a 1/8" clearance to the left door post, tighten the screws in the hinges snugly.
DO NOT OVER TIGHTEN. Re-adjust as necessary for proper alignment.
6. Note that two panels have gasket material on one edge. These pieces go on either side of the door.
Make certain that these two pieces are placed completely into the channel on either side of the door.
Failure to do this will make the rest of the glass installation impossible.
7. First loosen the glass retainers. This is a metal strip secured by one screw in the middle. Start with the
left door panel. The gasket must be on the right side of the panel.
8. Slide the gasketed edge completely into the channel on the side of the door. The left edge of the glass
should now fi t into the button at the bottom of the glass.
9. Lower the glass into the lower glass clip.
10. Repeat steps 8 and 9 with the right door panel. The gasket will be on the left side of the panel with the
not polished edge at the top.
11. The remaining panels can now be installed. The edge that is not polished is placed at the top. As each
panel is installed replace the glass retainer in place but do not tighten.
12. After all the glass panels are installed center the panels to reduce any gaps that may be between the
glass panels.
13. Tighten the glass retainers.
Do Not use substitute materials to replace the ceramic
glass panels.
Do Not slam the door shut or strike the ceramic panels
with objects as breakage may occur.
Do Not operate this appliance with broken or missing
glass panels.
Do Not clean the glass while the unit is hot.
Clean the ceramic glass panels with a nonabrasive glass
cleaner. To clean the opposite side from the door simply
remove the back glass panel to reach the glass opposite the
door.
WARNING!
Gas Carousl Page - 5
Hood
Retainer
and Screw
Glass
Lower Glass
Button
Upper Glass
Channel
Gas Carousel 4/08/15
Publicité
