Dörr SL-480 SET Notice D'utilisation page 13

05 | FIRST STEPS
CAUTION: Before connecting or disconnecting cable connections, make sure that the main switch (11) is on
position O = Off.
Insert the connection plug (12c) into the socket (07) at the ring light. Plug the power cable (12b) into the power cable socket (12a) and
connect the power supply to a socket outlet.
Switch on the LED light at the main switch (11): position I = On.
CAUTION: After each use please turn off the ring light (main switch 11 = position O = Off).
06 | OPERATION WITH RECHARGEABLE BATTERIES
Alternatively, the SL-480 ring light can be operated with 2 pcs Li-Ion batteries (Replace-) Sony NP-F750 or NP-F970 (optionally
available from DÖRR).
CAUTION: Before inserting or removing the Li-Ion batteries, make sure that the ring light is turned off (main switch (11)
to position O = Off).
Insert the Li-Ion batteries into the battery slots (05) with the battery contacts facing to the battery contact pins (06). Slide the battery
fully forward until it touches the battery contact pins (06).
Turn on the ring light at the main switch (11): position I = On.
NOTE: Please remove the batteries when ring light is not in use for a long period of time.
To remove the Li-Ion batteries, slide the batteries backwards and remove them out of the battery slots.
07 | OPERATION
Turn on the ring light at the main switch (11): position I = On.
Press the control knob (10) briefly. The LED display for colour temperature (08) is flashing. Turn the control knob (10) to select the
desired colour temperature from 3200K to 5500K.
Press the control (10) to confirm your selection and to enter the setting for brightness from 0 - 99% (corresponds to 100%
brightness).
Alternatively, the settings as described above can be made also with the front control knob (2).
CAUTION: After each use please turn off the ring light (main switch 11 = position O = Off).
13 doerr-foto.de