Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
water supply
line
quick-connect
fitting
copper
tubing
saddle
valve
On
Installation Instructions cont.
13.
Connect water supply line from
saddle valve to spout copper tubing with
the factory-assembled quick-connect
fitting. Push water supply line tubing
straight into fitting as far as it will go. Pull
on tubing.
NOTE: Do NOT plug power supply cord into outlet.
14.
Turn Temperature Control
counterclockwise to "Off" position.
15.
Push down and turn the
On/Off Cap clockwise to open spout.
Hold cap open to fill tank (about 1
minute). When tank is full, water will
flow from spout. Release cap.
NOTE: Turn Temperature Control to
"Off" position before plugging hot
water dispenser into power supply.
If tank is empty and thermostat is
in an "On" position when the
16.
Plug power supply cord into
grounded outlet.
Turn Temperature Control clockwise
to highest position.
Water in tank will reach maximum
temperature in approximately
15 minutes.
When water is heating, you may hear
gurgling noises coming from the tank.
There may also be some spitting or
The tubing should not come out when
properly installed. Turn the saddle valve
handle counterclockwise
water line.
power supply cord is connected,
the heater will overheat causing
an unpleasant taste, black specks
in the water, and permanent
damage to the heater seals.
hot water flow from the faucet. This is
normal for the initial heat-up of the
dispenser.
Turn Temperature Control to lower
temperature setting if you notice
vapor or hear boiling noise.
NOTE: Temperature Control
controls tank heater, not water
delivery. Rotate Temperature
Control clockwise to raise water
temperature, counterclockwise to
lower water temperature.
to open
9
Publicité
Chapitres
Table des Matières
