Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
quick-
connect
fitting
clamp
clear
tubing
closed
open
8
Installation Instructions cont.
NOTE: Do NOT plug power supply cord into outlet.
8.
Connect 1/4" (6.4 mm) spout
tubing (longer tubing) to the rear
quick-connect fitting on top of tank.
Push tubing straight into fitting as far
as it will go. Pull on tubing. The
tubing should not come out when
properly installed.
9.
Connect clear tubing from spout
to center tank tubing using clamp.
Make sure clear tubing does not kink.
10.
Install saddle valve following
kit instructions. If water supply line is
not copper, shut off water supply and
11.
Turn saddle valve handle
clockwise
until lance pierces soft
copper tubing and valve is firmly
seated. If the water line is not copper,
turn the saddle valve handle
clockwise until the valve is firmly
seated. The valve is now in the
closed position.
12.
Slowly open saddle valve and
flush line into bucket to remove any
foreign material that may have been
trapped in the supply line during
saddle valve installation.
Close saddle valve.
Do Not lengthen, twist or tightly
bend tubing.
drain line. Drill a 1/4" (6.4 mm) hole
into water supply line for the saddle
valve piercing pin.
Place a bucket under open end of
water supply line. Turn on main water
supply valve to pressurize cold water
line. Check for leaks.
Publicité
Chapitres
Table des Matières
