Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Tools and materials needed
ruler or
measuring tape
pliers
pencil
flat-blade
screwdriver
tubing cutter
1/4" (6.4 mm)
drill bit
hand or
electric drill
open-end wrench(es)
to fit saddle valve
1/4" (6.4 mm) O.D.
copper tubing
bucket or pan
2 mounting bracket screws (and
2 plastic anchors if attaching to
dry wall)
Saddle valve kit to fit
water supply line
Kit must meet all local
codes and ordinances.
Parts supplied
Remove parts from packages.
Check that all parts were
included.
spout
assembly
gasket
clamp
tank
mounting
bracket
tank
Electrical requirements
WARNING
gloves
Electrical Shock Hazard
safety
glasses
Plug into a grounded 3 prong
outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in death,
fire, or electrical shock.
If codes permit and a separate
ground wire is used, it is
recommended that a qualified
electrician determine that the
ground path is adequate.
A 120-volt, 60-Hz, AC-only 15- or
20- ampere fused, grounded
electrical supply is required. It is
recommended that a separate circuit
serving only your hot water dispenser
be provided. Use an outlet that
cannot be turned on/off by a switch.
Water supply requirements
If local codes permit, the hot water
dispenser feed line should be
connected to the cold water supply
line using a saddle tapping valve.
Important: If local codes Do Not
permit the use of saddle valves,
special feed valves can be
obtained from your local plumbing
supply distributor.
Connection to hot water line is not
recommended. Energy will be wasted
in heating the water twice and the
magnesium rod used in household
heating may produce a "rotten egg"
taste.
Before You Start
cont.
3-prong
ground-type
wall receptacle
ground
prong
power
supply cord
Recommended ground method
For your personal safety, the hot
water dispenser must be grounded.
This appliance is equipped with a
power supply cord having a 3-prong
ground plug. To minimize possible
shock hazard, the cord must be
plugged into mating, 3-prong, ground-
type wall receptacle, grounded in
accordance with all national and local
codes and ordinances. If a mating
wall receptacle is not available, it is
the personal responsibility and
obligation of the customer to have a
properly grounded, 3-prong, wall
receptacle installed by a qualified
electrician.
If this unit is replacing a hot water
dispenser connected to a hot water
supply, the existing connection may
be used.
A water filter is recommended if
your water supply contains sand,
grit or other particles. If a filter is
used, the water pressure to the
dispenser should not drop below
20 psi (138 kPa).
3-prong
ground
plug
5
Publicité
Chapitres
Table des Matières
