Programming Mode For Dm 4R Ovens; Residual Risk - Zhermack furnace DM Serie Manuel De L'utilisateur

PROGRAMMING MODE FOR DM 4R OVENS

7.15
The programming mode for the DM 4R oven is exactly the same as on the DM oven.
7
Figure
8
Figure

RESIDUAL RISK

7.16
Residual risk is:
• a danger that cannot be completely eliminated through design and application of safety devices.
• a potential danger which cannot be highlighted.
DM series ovens reach very high temperatures and thus allow specific odontotechny materials to be
fired; the residual risks thus consist of:
• accidental contact (and/or caused by a safety system fault) with the materials or the equipment
itself, during and after the melting phase (risk of serious burns to limbs).
• inhalation of fumes or combustion gas caused by backflow from an incorrectly positioned
aspiration tube.
• work carried out on the equipment interior by unauthorised personnel.
170 of 272
EN
Fig. 7: Make sure that the switch (P) to the right of the
panel is turned downwards to position 0. This ensures
that when the oven goes to Phase 2, the pan (N) starts
turning and the red LED (O) comes on.
Fig. 8: When the door is opened the pan stops. To bring
it into the desired position act on the ENTER key.
MAINTENANCE AND USE MANUAL
FURNACE DM