Safety Information; Assembly; Installing The Hose Holder - Parkside WU9925856 Instructions De Montage Et Consignes De Sécurité

Safety
information
ATTENTION! READ ASSEMBLY-
AND OPERATING INSTRUCTIONS
BEFORE USE! KEEP THE ASSEM-
BLY AND OPERATING INSTRUC-
TIONS IN A SAFE PLACE!
KEEP OUT OF THE
REACH OF CHILDREN.
THIS PRODUCT IS NOT A
TOY! INJURIES MAY OTH-
ERWISE OCCUR!
This hose is designed for
tap water. Do not drink
water from this hose. Otherwise
there is a risk of injury.
Be sure water from the hose can-
not return to the drinking water
supply: Disconnect the hose from
the tap after use, or install a back-
flow preventer or pipe interrupter
between the tap and hose.
Never leave the hose unsuper-
vised – even if the water flow is
temporarily interrupted. Other-
wise injuries or property dam-
age may occur.
Do not subject the
hose to frost. Other-
wise property damage may occur.
Ensure particles of dirt do not
plug the connectors or enter the
8 GB/IE/NI
hose. The fittings may otherwise
be damaged.
Do not aim the water jet at elec-
trical equipment, in order to e.g.
avoid a short circuit.
Do not aim the water jet at
persons or animals in order to
prevent injuring them.
Always close the water intake
after every use.

Assembly

You will need:
Cross-tip screwdriver (PH2)
Power drill, drill bit ø 6 mm
Important! Please refer to the
operating instructions of your power
drill.
Ensure that you do not damage any
electrical cables, gas or water pipes
when you drill into the wall.
Before first use, check that all con-
nections are securely connected
and re-tighten them if necessary.
Installing the
hose holder
Install the hose holder
in Figure A.
is shown
7