Clearvue - KitchenAid KBLC36MHS01 Guide D'utilisation Et D'entretien

Refrigerator features

ClearVue

™ Humidity-
Controlled Crispers With
RollerTrac
The humidity-controlled crispers are designed to keep
fresh vegetables and fruits longer. The crisper controls are
located on the front of the crisper shelves. The controls
adjust the humidity (moisture) in the drawers. Slide
control to "HIGH" for lettuce, cabbage and other
produce with leaves. Slide control to "LOW" for apples,
pears and other produce with skins.
The humidity-controlled crispers are interchangeable.
The ClearVue areas allow you to see into the crispers
without opening them.
IMPORTANT: Occasionally, a food item may freeze in
the FreshChill ™ Deli Locker, utility drawer, or crisper.
When this occurs, turn the FreshChill Deli Locker
temperature control to "cold."
To remove crisper cover:
1. Remove food from crisper cover.
2. Pull both crispers out about four inches.
3. Reach under the glass shelf with both hands and lift
gently upwards until back of shelf is free.
4. Tilt shelf at an angle and remove shelf from refrigerator
being careful not to bump glass.
To replace crisper cover:
1. Holding glass shelf firmly with both hands, tilt shelf at
an angle and position it above support rails.
2. Place shelf gently on support rails on side wall.
3. Replace food on crisper cover.
8
™ System
To remove both crispers:
1. Roll crisper out to the stop.
2. Lift front of crisper and pull out the rest of the way.
To replace both crispers:
1. Place rear crisper rollers into front of track.
2. Push crisper straight back.
Center
support