Door Removal & Replacement - Danby Designer DFF177A1WDD Guide D'utilisation Et D'entretien

Handle
Move the door handle from one side of the door to the other.
1. Loosen setscrews located on side of handle at each end. See
Graphic 1.
2. Remove handle from grommets.
3. Using a Phillips screwdriver, remove the grommets from the door.
4. Position the grommets on the opposite side of the door and
reinstall.
5. Position the handle over grommets on the opposite side of the
refrigerator door.
6. Ensure grommets are fitted into handle holes.
7. Tighten the upper and lower setscrews with hex key provided. Do
not overtighten setscrews.
Replace Door and Hinges
NOTE: Graphic may be reversed if door swing is reversed.
1. Replace the parts for the bottom hinge as shown and tighten
screws. See Bottom Hinge graphic. Replace the refrigerator door.
NOTE: Provide additional support for the door while the hinges are
being moved. Do not depend on the door magnets to hold the door
in place while you are working.
2. Assemble the parts of the top hinge as shown in the Top Hinge
graphic. Do not tighten the screws completely.
Door Removal &
Replacement
Top Hinge
B
A. Top Hinge Cover
B. 5 / " Hex-Head Hinge Screws
16
C. Top Hinge
Bottom Hinge
B
A. Hinge Pin
B. 3 / " Hex-Head Hinge Screws
8
Door Swing Reversal and Handle Removal (optional)
A
B
A
C
A. Grommet
B. Handle
C. Setscrews
A
A
A. Hinge Pin
B. 3 / " Hex-Head Hinge Screws
8
Final Steps
1. Check all holes to make sure that hole plugs and screws are in
place. Reinstall top hinge cover. See Top Hinge graphic.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
2. Plug into a grounded 3 prong outlet.
3. Reset the control. See "Using the Control."
4. Return all removable door parts to door and food to refrigerator.
1
A
A. Cabinet Hinge Hole Plugs
B
C
3
B
5
WARNING
2