Publicité
Les langues disponibles
Les langues disponibles
Setting the temperature
(fig. A, C & D)
The temperature must be set according to the
type of fabric.
Warning! Always turn the temperature control
dial to the 'min' position before inserting the
mains plug into the wall socket or removing
the mains plug from the wall socket.
•
Turn the temperature control dial (7)
clockwise to increase the temperature.
The temperature indicator (8) remains on
during the process. The temperature
indicator (8) goes off when the soleplate
(15) has reached the required temperature.
•
Turn the temperature control dial (7)
counterclockwise to decrease the
temperature. The temperature indicator (8)
remains on during the process.
The temperature indicator (8) goes off
when the soleplate (15) has reached the
required temperature.
Label
Type of fabric
(fig. D)
A
The fabric must not be ironed.
B
Synthetic (acryl, modacrylic,
polypropylene, polyurethane)
C
Synthetic (acetate, triacetate) B
C
Synthetic (metal, nylon,
polyester, viscose)
C
Silk
C
Wool
C
Cotton
D
Linen
"Water reservoir empty" indicator
(fig. A)
If the water level in the water reservoir (13) is
too low, the "water reservoir empty" indicator
(11) will come on to indicate that the water
reservoir must be refilled.
Note: The steam generator is protected with a
safety valve. The cover can only be removed
from the water reservoir when the pressure is
below 1 bar.
•
Switch off the steam generator (4) using
the on/off switch (5).
•
Switch off the iron (1) using the on/off
switch (2).
•
Remove the mains plug from the wall socket.
•
Allow the appliance to cool down completely.
•
If necessary, press the steam button (9) to
decrease the pressure in the water reservoir
more rapidly.
•
If the pressure has lowered sufficiently,
loosen the cover (18) from the water
reservoir (13).
•
Fill the water reservoir (13) with the
indicated amount of water.
Refer to "Filling the water reservoir".
•
Tighten the cover (18) to the water reservoir
(12).
Hints for use
Dry ironing
Temperature
•
Fill the water reservoir (13) with water.
(fig. C)
•
Place the iron (1) with the soleplate (15)
onto the iron holder (16).
•
Insert the mains plug into the wall socket.
•
Switch on the iron (1) using the on/off
A
switch (2). The on/off indicator (3) comes on.
The iron starts heating.
•
Set the temperature using the temperature
B
control dial (7). The temperature indicator
B
(8) remains on during the process.
C (dry ironing /
•
If the temperature indicator (8) goes off,
steam ironing)
the soleplate (15) has reached the required
C (dry ironing /
temperature. The iron is ready for use.
steam ironing)
•
If you interrupt the process, place the iron
C (dry ironing /
(1) with the soleplate (15) onto the iron
steam ironing)
holder (16).
•
After use, place the iron (1) with the
soleplate (15) onto the iron holder (16).
•
Switch off the steam generator (4) using
the on/off switch (5).
•
Switch off the iron (1) using the on/off
switch (2).
•
Remove the mains plug from the wall socket.
•
Allow the appliance to cool down completely.
13
Publicité
