Publicité
Les langues disponibles
Les langues disponibles
User Manual
Installation
Please follow the steps below for installation when using HDMI equipment, if you are using DVI
equipment, please substitute the HDMI cables for DVI to HDMI cables where required.
1. Connect your HDMI source to the HDMI Transmitter Unit using a HDMI cable.
2. Connect one end of the Cat.5e/6 cable (maximum length 50m) to the RJ-45 port on the
transmitter unit, and the other end of the cable to the RJ45 port of the receiver. Please use solid
core installation cable of Cat.5e UTP or higher.
3. Connect your HDMI display device to the HDMI output port on the receiver unit using a HDMI
cable.
4. To use the IR remote signal functionality, connect the included IR extension cables to the correct
IR ports on the transmitter and receiver units.
5. Place the IR emitter Eye of either unit in front of the IR port of the equipment you want to control,
ensuring the receiver Eye is in a clear line of sight of the IR remote.
6. Power on both the HDMI source and display.
7. Plug the DC power supply into the Transmitter or Receiver unit, the Power LED will illuminate
green.
8. Once connection is successful to a video source, the Status LED will illuminate.
Troubleshooting
There is no display on the screen.
Check that the DC plug and jack used by external power supply are firmly connected.
Check that the Cat.5e/6 cable is plugged in correctly and that the Power/Status LED are illuminated.
Check that the HDMI source and display are both powered on and active.
Power off all the devices, then power on in this order: first, the transmitter unit, then the display and
finally the source.
For some HDMI devices it may be helpful to unplug and re-plug their HDMI connection to re-initiate
the HDMI handshake and recognition.
Reduce the length of Cat.5e/6 or HDMI cable used, or use a higher quality cable. Please refer to the
Introduction section for the maximum distance/resolution/cable combinations.
Connect the power supply to the other side of the installation to which you currently have it
connected.
English
Publicité
