BH HIPOWER SK Line G790 Mode D'emploi page 11

GENERAL INSTRUCTIONS.-
The electronic monitor is designed to be easy and intuitive to use. The messages that appear on the bottom
screen (B) will guide the user throughout the whole exercise.
Nevertheless, we recommend that the gym instructor reads through this section carefully to become fully
familiar with the electronic monitor in order to show the user how to operate it correctly.
This monitor screen is touch sensitive, so to press a key just place your finger on the said key displayed on
the screen.
NOTE: The monitor will switch back to stand-by mode after 4 minutes if no keys are pressed. The monitor
can be switched back to READY by pressing the STOP key.
PERSONALISING THE ELECTRONIC MONITOR.-
Follow the procedure below to access the monitor's personalisation mode:
With the machine and the monitor switched off, press and hold the RESET key and turn the main switch (b)
to position 1 Fig.A, located at the bottom front of the machine.
1) CHANGING LANGUAGE.-
With the monitor on, the word "LANGUAGE" will appear flashing on the alphanumeric screen (B), Fig.1.
Press the ENTER key and the current language will start flashing. Select your language using the SPEED▲
and SPEED▼ keys and then press ENTER, the word "LANGUAGE" will start flashing again, using the
SPEED▲ key, pass on to the (2 Sounds) setting on the adjoining bottom screen.
2) CHANGING THE SOUND.-
With the word "SOUNDS" flashing, press the ENTER key and the word ON or OFF will start flashing. Select
the flashing value using the SPEED
"SOUNDS" will start flashing again, using the SPEED
bottom screen.
3) CHANGING THE WELCOME MESSAGE.-
With the word "TEXT" flashing, press the ENTER key and the word ON or OFF will start flashing. Select the
option that is flashing by using the SPEED
change the monitor's welcome message.
Once the ON option has been selected, press the ENTER key and a flashing cursor will appear on the
alphanumeric screen (B). Use the SPEED
Once you have finished entering the message, press the ENTER key for a few seconds and the word "TEXT"
will start flashing. Use the SPEED
screen. If you wish to exit the personalisation mode press the STOP key.
4) MAX. EXERCISE TIME.-
With the word "MANUAL T" flashing, press the ENTER key and a figure between 0 and 60 minutes will start
flashing. Select the flashing value using the SPEED
the word "MANUAL T" will start flashing again, using the SPEED
on the adjoining bottom screen. If you wish to exit the personalisation mode press the STOP key.
ENGLISH
Fig.A
and SPEED- keys and then press ENTER to confirm, the word
key to pass to the (3 Text) setting on the adjoining
and SPEED- keys Choosing the ON option allows you to
and SPEED- keys to enter a welcome message letter by letter.
key to pass on to the (4 Manual T) setting on the adjoining bottom
and SPEED- keys and then press ENTER to confirm,
11
key , pass on to the (5 SPR time) setting
SK
LINE LINE
LINE LINE
sportkoncept