MTX Audio iWa225 Manuel Du Propriétaire page 3

Remote control keys
1. Power OFF : use to switch off the unit. Note that it doesn't switch on the unit...
2. Aux input : push once to switch on the iWa225 and use the AUX input.
->The right red LED will switch on
3. Bluetooth input : Push once to switch on the iWa225 and to use the BT input.
->The left blue LED will switch on
4. Volume UP : use it to raise the volume level
5. Skip backward : push once to go back in track (only available in BT)
6. Skip forward : push once to go next (only available in BT)
7. Volume Down : use it to reduce the volume level
8. Play/Pause : push once to play or pause the track(only available in BT mode)
9. BT paring : Push once to pair a new device to with your iWa225.
Push once to release the BT connexion.
Quick start
1. Screw the antenna
2. Connect the speakers. It is important to respect the speaker polarities to get a good sound and a good bass response. Note that the
minimum speaker load is 4Ω
3. Connect the RCA inputs if available
4. Connect the IR sensor and make it visible for the IR remote control
5. Connect the power cable to a wall socket. Your iWa225 is ready
6. On the remote control, remove the battery protection to activate it
7. Press the Aux input or the BT input on the remote control. The amp is on.
8. If you use the Aux input, adjust the volume level.
9. If you use the Bluetooth input, go to the next paragraph.
Bluetooth paring
1. First connexion : push the Bluetooth key (n°3) on the remote control. The unit is switching on and the blue LED is now on.
2. Push once on the "BT paring/release" key (n°9) on the remote control. The blue LED is now flashing blue. The unit is ready to pair.
3. On your BT device (Cell phone, iPad, computer...), go to the BT preferences and tap on "MTX iWa225" to pair the devices together.
4. When it is done, go to your music app and play a track.
Note 1 : After 1 minute without BT signal, the unit will switch to Aux automatically if it detects signal on Aux.
Note 2 : You have to be in BT input to release BT.
Note 3 : You can always release the MTX iWa225 and make it available for an other BT device by simply pushing the "BT paring" (n°9) key
on the remote control. You don't need to disconnect the devices, just push once "BT paring" (n°9).
Recycling
Do not trash this product. You must deliver it to the applicable collection point for recycling. The iWa225 is made of highly recyclable com-
ponents and materials.
How to Stay Tuned :
https://www.facebook.com/MTXEurope
https://twitter.com/MTXEurope
http://www.mtxaudio.eu