GE GSD3300KCC Instructions D'installation page 14

Dishwasher Installation
STEP 19: DISHWASHER WET TEST
CHECKLIST
• Turn on power supply or if power cord is used,
plug it into the wall outlet.
• Latch dishwasher door.
• For electronic dishwashers, select the NORMAL
WASH cycle and press the START pad one time.
Cycles
P
OTS H N C R
EAVY ORMAL HINA INSE
& P
ANS W W C O
ASH ASH RYSTAL NLY
• For dial models, press the NORMAL and HOT
START pads, if model has them, and then turn the
control dial just enough to start the dishwasher.
Prewash Option" depending on model.
Cycles
P ots Heavy Normal Hot Hi- T emp Hea t ed
& P ans W ash W ash S ta r t W ash D r y
Appearance varies by model. Not all models have push buttons.
• Check to be sure that water enters the
dishwasher. This could take up to 4 minutes.
If water does not enter the dishwasher:
– Check to be sure that the water is turned on.
14
C
LEAN
C
LEAN
2 4 8
H L D
HI T HI T EATED OCK ELAY S
EMP EMP TART
R W D H
INSE ASH RY (2 T IMES ) OURS
R
ESET
Hot Start
Option S ta r t
S ta r t Delay
(HRS)
Cycle
on
Off
Pla t e W armer
R eset (Heated D r y On)
Rinse Only
(Heated D r y Of f )
Flood Float
Cover
– Check the electrical connection to the water
valve. The red electrical connector should be
plugged into the dishwasher water valve. If it
the dishwasher. Plug the red connector into the
dish washer water valve and then restore power.
• Check for leaks under the dishwasher. If a leak is
Light W ash
restore power.
• Check for leaks around the door. A leak around
the door could be caused by the dishwasher door
rubbing or hitting adjacent cabinets. Reposition
the dishwasher if necessary. See Steps 11, 12
and 13.
• Most dishwasher models will drain about
for leaks when dishwasher drains. If leaks are
and then restore power.
• Open the dishwasher door and make sure most
of the water has drained. If the water does not
drain, check to be sure disposer plug has been
removed and/or air gap is free of debris.
drain cycle. Check again to be sure there are no
leaks.
• At the end of the second drain, push the reset pad
on electronic models. For dial models, unlatch the
Red Connector