Dangers Due To Electrical Power; Commissioning - CASO DESIGN HB 2200 PRO Mode D'emploi

Danger
►
After 1 minute operation: Let the device cool down for 2
minutes. Stop for half an hour after 5 cycles.

12.3.2 Dangers due to electrical power

Danger
Mortal danger due to electrical power!
Mortal danger exists when coming into contact with live wires or
subassemblies!
Observe the following safety notices to avoid dangers due to
electrical power:
►
If the connection lead is damaged, you will need to have a
special connection lead installed by an authorized electrician.
►
Do not operate this device if its power cable or plug is
damaged, if it does not work properly or if it is damaged or
has been dropped. If the power cable is damaged, it will need
to be replaced by the manufacturer or his service agency, to
avoid any dangers.
►
Do not open the housing on the device under any
circumstances. There is a danger of an electrical shock if live
connections are touched and the electrical or mechanical
structure is altered. In addition, functional faults on the device
can also occur.

12.4 Commissioning

This chapter provides you with important safety notices during the initial commissioning of
the device. Observe the following notices to avoid dangers and damages:
26