Aspire Typhon 100W Manuel D'utilisateur page 24

22
Using the Device
Settings in TCR Mode
Once you have selected TCR Mode, you can access
the "PWR" and "TCR" settings by pressing the "+" and
"-" buttons at the same time. Press the Fire button to
choose between these settings. You can now alter the
calibration with the "+" and "-" buttons. You can set the
wattage between 1W and 200W in "PWR", while you
can access the fine calibration range between 0.10 and
0.99 in "TCR". The settings cannot be adjusted for TC
(NiI/Ti/SS316L).
Settings in CPS Mode
In CPS (Customizable Power Settings), you can finely
calibrate the power curve by pressing the "+" and "-"
buttons at the same time. You can adjust the wattage
with "+" and "-", use the Fire button to select between 1
and 10 seconds.
Switching between °C and °F
In order to change the unit of temperature from Fahren-
heit (F) to Celsius (C), increase the temperature value
to the maximum or minimum level. If you change the
set value even further above or below this range, the
display will automatically switch to the other unit.
Attaching the Clearomizer
A Clearomizer can be attached when TC mode is selec-
ted. The message "New Atomizer?" will then appear on
the display first, followed by "YES+/NO-". If you choose
"YES+", the battery carrier adopts the resistance of
the new head. With "NO-", the preselected resistance
settings remain in place. (Please ensure that the screen
is on when you first install a new Clearomizer and the
attached head is at room temperature).
Rotate the display
The screen rotates automatically to ensure better
functionality.