NEC MultiSync LCD1850E Mode D'emploi page 7

Quick Start
Tilt and Swivel
Grasp both sides of the monitor screen
with your hands and adjust the tilt and
swivel as desired (Figure TS.1).
Remove Monitor Stand for
Mounting
To prepare the monitor for alternate mounting
purposes:
1. Disconnect all cables.
2. Place monitor face down on a non-abrasive surface. (Place the screen on
a 2-inch platform so that the stand is parallel with the surface.)
(Figure S.1)
3. Remove the stand cover by sliding the top/bottom pieces off the stand
(Figure S.2). Remove the 4 screws connecting the monitor to the stand
and lift off the stand assembly (Figure S.3). The monitor is now ready for
mounting in an alternate manner.
4. Reverse this process to reattach stand.
NOTE: Use only VESA-compatible alternative mounting method.
Caution: Use the original screws (4 pcs) when mounting to avoid damage to the monitor and stand. To
fulfil the safety requirements the monitor must be mounted to an arm which guaranties the
necessary stability under consideration of the weight of the monitor. The LCD monitor should
only be used with an approved arm (e.g. GS mark).
–continued
2-in
Figure S.1
Figure S.2 and Figure S.3
5
Figure TS.1
4
3
1
2