Heitronic 28030 Instructions D'installation Et D'utilisation page 9

Changing the illuminant:

Use only illuminants listed in the technical specifications. The use of other illuminants may
cause the light to overheat.

Disconnect the power supply before changing the illuminant.

If you are replacing the illuminant immediately after the light has failed, wait until the light has
cooled off sufficiently.

Carefully unscrew the light cover and remove the defective illuminant. Carefully insert the new
illuminant and make sure the illuminant is properly installed in the socket. Do not apply too
much force or pressure.

Switch the voltage supply back on.
Maintenance and care:

Prior to cleaning the light, make sure it has been disconnected form the power supply.

Use a dry or slightly moistened cloth for cleaning.

Never use any chemicals, flammable cleaning agents or abrasives. These may cause damage
to the surface coating and/or the insulators of the light.
Disposal:

Used electronic devices must be collected for recycling and must never be disposed off with
regular household garbage.
Installation instructions Art. no. 287030, 29032 28035, 28037
Heitronic
H. Vollmer GmbH
Allmendring 29
D-75203 Königsbach-Stein
Page 3 of 3
®
Last revision 08.2007