Selecting The Telephone Muting; Selecting The External Component To Use (Only For Kd-Sx878R) - JVC KD-SX878R Manuel D'instructions

Selecting the telephone muting

This mode is used when a cellular phone system is connected. Depending on the phone
system used, select either "MUTING 1" or "MUTING 2", whichever mutes the sounds from
this unit.
When shipped from the factory, this mode is deactivated.
• MUTING 1: Select this if this setting can mute the sounds.
• MUTING 2: Select this if this setting can mute the sounds.
• OFF: Cancels the telephone muting.
1. Press and hold SEL (Select) for more than 2 seconds to call up the general settings mode.
2. Select "TEL" with
3. Select "MUTING 1," "MUTING 2" or "OFF" with the control dial.
The telephone muting mode changes as follows:
Selecting the external component to use
(ONLY FOR KD-SX878R)
You can connect the external component to the CD changer jack on the rear using the Line
Input Adaptor KS-U57 (not supplied).
To use the external component as the playback source through this unit, you need to select
which component — CD changer or external component — to use. When shipped from the
factory, CD changer is selected as the external component.
• LINE IN:
• CHANGER:
1. To change the source to FM, AM or CD, press FM/AM or CD.
2. Press and hold SEL (Select) for more than 2 seconds to call up the general settings mode.
3. Select "LINE IN" with
4. Select the desired mode with the control dial.
The external component selecting mode changes as follows:
Note:
For connecting the Line Input Adaptor KS-U57 and the external component, refer to the Installation/
Connection Manual (separate volume).
30
¢ or
4
.
MUTING 1
To use the external component other than CD changer
To use the CD changer
¢ or
LINE IN CHANGER
MUTING 2
4.
OFF