How To Fill Rinse Aid - Haier DW12-TFE5 Serie Mode D'emploi

How to fill rinse aid

Rinse aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door .
When the low rinse aid indicator "H"on the control panel and the me-
chanical indicator "H1" on the dispenser light, you must load rinse
aid.
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your appliance,
you must proceed as indicated below when loading the rinse aid.
To open the dispenser, turn the "1" cap in an anti-clockwise direction
and then pour in the rinse aid, making sure not to overfill. The amount of
rinse aid used for each cycle can be regulated by turning the " 2" dose
adjustor, located beneath the "1" cap, with a screwdriver. There are 6
different settings; the normal dosage setting is 3.
Important
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes or spot-
ting occurs, the dosage adjustor should be turned to a higher setting. If the dishes have white
streaks, turn the dosage adjustor to a lower setting.
H
I
H1
1 2
EN
8