Publicité
Les langues disponibles
Les langues disponibles
• Read, understand, and follow all printed materials provided with and on this product before use.
• Do not exceed rated capacity! Rated capacity is 450 lbs. (includes user, tools, equipment and personal items).
• Sit down gently! Avoid shock loads caused by jumping or falling onto seat.
• Do not stand on seat.
• Beware of pinch and crush hazards when folding and unfolding.
• Keep out of the reach of children! This device is not appropriate for children's use.
• Use only on hard, level surface capable of supporting the load.
PREPARATION
Before assembling your Folding Creeper, make sure all
parts are present. If any part is missing or damaged, do not
attempt to assemble or use the product. Contact Omega Lift
customer service for replacement parts.
Package Contents: 1 Head Frame Section, 1 Middle Frame
Section, 1 Rear Frame Section, 4 Hex Bolts, 8 Washers, 4
Hex Nuts, 6 Casters, 4 Caster Fasteners.
Figure 2 - Creeper Frame assembly
Figure 3 - Attaching Creeper Casters
ASSEMBLY INSTRUCTIONS
1. Place Creeper Sections face down, arranged as shown in
Fig. 2 (note Middle Section orientation).
!
WARNING
To avoid personal injury and property damage:
2. Connect Creeper Sections using Hex Bolts, Washers and
Nuts. Tighten Nuts firmly, but not enough to bind Creeper
adjustment.
3. Insert Lock Pin into hole in frame side. Check for proper
operation.
4. Using the included open-end wrench, attach two Casters
to the threaded holes in the Head Frame section. Use a
5mm hex key to fasten the remaining four Casters to the
Creeper Frame. Insert the threaded Fasteners from the
top and the Casters from the bottom, then tighten with hex
key.
OPERATING INSTRUCTIONS
1. Unlock the spring loaded Lock Pin by pulling out until
disengaged, at the same time rotate the Head Frame and
Middle Frame upward and back towards the Rear Frame
section until the Lock Pin can engage the Creeper Seat
Locking Sleeve (Fig. 4). Ensure Lock Pin is fully engaged.
Figure 4 - Adjusting Creeper to seat configuration
2 Flip Head Frame forward until horizontal.
3. Unlock the spring loaded Lock Pin by pulling out until
disengaged, then reverse steps 1, 2 to convert Creeper
Seat into Creeper.
Figure 5 - Adjusting Seat to Creeper configuration
3
Publicité
