Taking The Charger Into Operation; Indications - Victron energy Impulse S12 Manuel

7. TAKING THE CHARGER INTO OPERA TION
The charger can now be connected.
First of all you should plug the mains plug into the wall socket.
The charger enters the 'STAND-BY'-condition after flashing a combination of LED's..
Both LED's (yellow and green) are lighting.
Subsequently you can connect the battery and charging will start automatically. Only
the yellow LED is now lighting. At deep discharged batteries, first the battery is
charged with a small current (precharge). After that the battery is charged with the
nominal current (main charge). At last the battery is charged with a declining current
(post charge). The magnitude of these currents depends on the adjusted battery type.
When the yellow LED is switched off and the green LED on, the battery is full and can
now be disconnected. If the battery is not disconnected then the battery is kept in
optimal full state by a very low current.
When the battery is disconnected, it is allowed to let the mains plug in the wall socket.
The yellow and green LED's will light.
8. INDICA TIONS
Yellow LED Green LED
Charger off (mains not connected)
Charger just switched on and
showing the charge characteristics
Stand-by
Charging
Full
Failure
= Off
= On
= Blinking
8