Kemper 104997 Notice De Montage Et D'utilisation page 11

repaired before use. If you detect a leak and you cannot repair it, don't try to fix it another way, but
contact the customer service. Do not use a device that leakage, deteriorated or malfunctioning.
STARTING THE APPLIANCE
Note: This device is intended only for direct cooking of food. It is NOT allowed to use pots. Do not use
the appliance other purposes than cooking.
1. Put the hot plate on a stable and horizontal surface. Do not alongside two or more burners.
2. Put the hot plate far from inflammables substances or things that could be damaged by heat.
3. Before inserting the cartridge, open the bottle holder compartment and place the oscillating rod in a
vertical position by pressing as in Fig. 1. Do not use the rod as a support for the grid (Fig. 2).
Fig. 1
4. Make sure that the seals are in a good state before connecting the gas cartridge (see figure).
5. Never use the appliance with damaged or worn seals.
6. Check that the appliance is not damaged. Never use a damaged
appliance.
7. Make sure that the hot plate tap is CLOSED - Tap on position
"UNLOCK" (clockwise rotation).
8. Put the cartridge in its slot, placing the cut on its neck in
correspondence to the safety stop (fig. 3) and close the cartridge holder lid.
9. Place the lever connecting the cartridge on the "LOCK" position (fig. 4).
ATTENTION: the appliance is now ready for use. The positioning of the lever on "LOCK"
presupposes the immediate ignition of the stove (point 10) as the gas circuit is ready for
gas supply. Do not leave the appliance unattended and without flame with the lever
positioned on "LOCK".
Fig. 3
IGNITION
10. Turn anticlockwise all the way the tap until it is positioned on "
until ignition occurs.
11. Regulate the flame according to your needs.
12. Caution: The device is not equipped with a security system for the automatic closing of the gas.
SHUTTING DOWN THE APPLIANCE
1. To turn off the fire, rotate completely clockwise the tap to the "UNLOCK" position. During this
operation the cartridge will be automatically released from the autobounce system and consequently
the cartridge connection lever will automatically go to the "
2. Wait for the plate to cool before storing it.
3. In case of long periods of non-use of the product, it is compulsory to take the cartridge out of the
appliance.
4. This unit can be kept inside only if the cartridge has been disconnected and removed from the
appliance. If you expect that the barbeque remains unused for a certain period of time, store it in its
original packaging and in an environment free from dust.
DT Istr 104997 – 10/2014_Rev 8_11/2020
USE INSTRUCTIONS
Fig. 2
" position; continue the rotation
ʺ (OFF) position.
Fig. 4
11/28