Philips QT4045 Mode D'emploi page 7

Charge, use and store the appliance at a temperature between
15cC and 35cC.
This appliance is only designed for trimming the human beard.
Do not use the appliance for any other purpose.
Do not use the appliance if the cutting unit is damaged or
broken, as this may cause injury.
If the powerplug is damaged, always have it replaced by one of
the original type in order to avoid a hazard.
If the appliance is subjected to a major change in temperature,
pressure or humidity, let the appliance acclimatise for 30 minutes
before you use it.
Charging
Do not charge the appliance for more than 24 hours.
Charge the appliance for 10 hours before using it for the first time or
after a long period of disuse.
Make sure the appliance is switched off before you start charging it.
The appliance cannot be run directly from the mains.
1 Insert the appliance plug into the appliance and put the
powerplug in the wall socket.
Fully charging the appliance takes approx. 10 hours.
Charge the appliance at least 90 minutes for a single trimming session.
Battery indications
The charging light will go on to indicate that the appliance is
charging, but the charging light will not change colour or will not
go out when the appliance is fully charged (fig. 2).
Preparing for use
Always comb your beard or moustache with a fine comb before you
start trimming.
ENGLISH
7