Eaton HALO MSLED300W Manuel D'instructions

MSLED300W
(White/Blanco/Blanc)
MSLED300
(Black/Noir/Negro)
ENGLISH
ITEMS REQUIRED
(Purchase separately)
• Phillips screwdriver
HOW IT WORKS
During the daylight hours, the solar panel turns the sunlight
into energy that is stored in the rechargeable battery pack.
Your light features a motion sensor that turns the light ON
at night when motion is detected. This light is equipped
with a photocell, which only allows the fixture to turn ON
during the nighttime hours.
WARNINGS AND CAUTIONS
INSTRUCTIONS PERTAINING TO A RISK OF FIRE OR INJURY TO PERSONS.
To reduce the risk of fire or injury to persons, read and follow these instructions:
• DO NOT replace batteries.
• DO NOT dispose of this product in fire. Batteries inside this product may explode or leak.
• DO NOT puncture this battery pack. DO NOT work on this battery pack
• DO NOT disassemble fixture. The fixture does not have any user serviceable parts.
• Lithium-Ion batteries must be disposed of in accordance with local waste ordinances and
regulations.
• Do not operate luminaire with a missing or damaged lens.
• Fixture is suitable for wall mount only. NOT suitable for ground mount installation.
SAVE THESE INSTRUCTIONS.
FOR BEST RESULTS
• Allow fixture to receive four full days of sunlight before turning fixture ON.
• Locate fixture in an area that will receive the
maximum amount of sunlight during the daylight
hours. Panel must receive at least 3-4 hours of
direct sunlight daily.
• Test your charged unit before installing.
• Locate fixture so motion moves across the
detection zone (Fig. 1).
• Locate fixture away from heat producing sources to
prevent false triggering. Also be very careful not to
include objects such as windows, white walls and
water in the detection zone.
Questions?/Des questions?/ ¿Preguntas? 1-800-334-6871 ConsumerProducts@eaton.com
PACKAGING CONTENTS/ CONTENIDO DEL PAQUETE
A. Light fixture
Accesorio
Luminaire
120 degrees
Fig. 1
Instruction Manual/Manuel d'instructions/ Instrucciones
B. Snap-in mounting bracket
Soporte de montaje de sujeción a presión
Support de montage encastrable
Quick Release Tab
Lengüeta de liberación rápida
Languette à dégagement rapide
• Locate fixture away from moving objects such as trees, large shrubs and street traffic.
• Keep solar panel clear of any objects that will block the sunlight. It will be necessary to
periodically clean the solar panel with soft wet cloth.
• During periods of several cloudy days, the battery may fall below the operating level and
will need to be recharged with sunlight.
MOUNTING YOUR FIXTURE
Up to
25 feet
1. Locate area in which you would like to install your
light fixture.
NOTE: For fixture to operate properly, the fixture
must be located in an area that will receive the maximum
amount of sunlight and is free from obstructions.
2. Using the fixture mounting screws (C) provided,
mount the snap-in mounting bracket (B) to a solid
surface by placing the screws through the center
holes of the bracket. Make sure the tab on the
bracket is pointing down. (Fig. 2).
3. Slide power switch to AUTO.
4. Slide fixture down over the snap-in mounting
bracket, making sure that the fixture engages the
guide ribs. Continue sliding down until the fixture
snaps into the locking tab.
For Portable Use
1. Press the quick release tab on the mounting
bracket to remove fixture.
NOTE: Be sure to keep the fixture in the OFF position
when not in use to conserve the battery.
2. Slide fixture onto mounting bracket (Fig. 4) when
finished.
1
C. (2) Fixture mounting screws
(2) Tornillos de montaje del accesorio
(2) Vis de montage du luminaire
Fig. 2
B
C
C
Fig. 3
A
Fig. 4
A