Publicité
Les langues disponibles
Les langues disponibles
User Manual
3. Click continue to proceed with the installation, following the instructions on screen. When the
installation is complete, reboot the computer.
4. Once rebooted:
a. Connect the Transmitter unit via USB to the host computer
b. Connect the transmitter to the receiver with Cat.5 (or higher) cable up to a maximum length
of 70m
c. Finally connect the Receiver to your sink equipment via a serial RS232 cable
5. Run System Preferences on the host computer and select Network (Go > Applications > System
Preferences > Network), you should see the text "New Port Detected"
6. Click OK and select Network Port Configurations from the Show dropdown. The new port can be
enabled from this screen by checking the ON box and clicking Apply Now
7. At this point, it is possible to exit Network and use the device as a COM port
If you wish to set the device up a modem for an Internet connection, select the new port from the Show
dropdown, it should be displayed as usbserial-XXXX.
Note: Entries for the following screen are specific to the Internet account of each user contact your ISP
for details.
Uninstalling Instructions
1. Start a Terminal session (Go > Applications > Utilities > Terminal) and enter the following
commands at the command prompt:
cd /System/Library/Extensions
rm -r FTDIUSBSerialDriver.kext
cd /Library/Receipts
rm -r FTDIUSBSerialDriver.kext
2. The driver will then be removed from the system
To remove the port from the system
3. Run System Preferences and select Network. Selecting Network Port Configurations from the
Show menu will display the port as greyed out
4. Select the uninstalled port and click Delete
5. Confirm the deletion to remove the port
All manuals and user guides at all-guides.com
English
Publicité
