Publicité
Les langues disponibles
Les langues disponibles
18 Series Installation - Separate Units
Showerhead and Tub Spout Installation
4
A.
FOR TUB SPOUT INSTALLATION:
Refer to the installation instructions supplied with your spout. Do not connect deck mount spouts
to in-wall valves. Do not use hand showers connected in lieu of a tub spout to a tub/shower
valve. Do not use PEX tubing for tub spout drop.
B-1
2
B-2
B-3
3
2
4
1
1
1
3
2
FOR SHOWERHEAD INSTALLATION:
1
Connect top outlet (1) to shower arm (2)
with proper fittings. To prevent damage to
finish on shower arm, insert wall end of
shower arm into shower flange (3) before
screwing arm into riser connection. Thread
showerhead (4) onto shower arm. Apply
plumber tape to pipe threads on both ends.
Do not overtighten showerhead.
Slip-On Installation
The copper tube (1) must be 1/2" nominal
copper. Important: If it is necessary to cut the
copper tube, the end must be chamfered free
of burrs to prevent cutting or nicking O-ring
inside the spout. Slide spout over copper tube
flush with the finished tub or wall surface.
Tighten set screw (2), but do not overtighten.
Iron Pipe Installation
Install threaded pipe nipple (1) to extend past
finished wall. Apply plumber tape to threads
on pipe nipple and screw on tub spout.
Copper Sweat Installation
Remove O-ring (1) from adapter (2). Solder
adapter to tube taking care to keep solder away
from O-ring groove. CAUTION: NO SOLDER
PERMITTED ON OUTSIDE DIAMETER OF
ADAPTER ADJACENT TO O-RING GROOVE.
Cut off tube (3) and replace O-ring on groove of
brass adapter. Thread tub/spout onto adapter,
taking care not to damage O-ring, and hand
tighten until spout is firmly against finished wall
and all slack is taken up behind wall.
8
Publicité
