Publicité
Les langues disponibles
Les langues disponibles
18 Series Installation - Single Units
Jetted Shower™ Trim Installation
2
A.
1
2
Turn off water supplies. Unscrew test caps
(1) from the body. If this is not a thin wall
mounting, the entire plasterguard may be
removed. Remove bonnet nut (2) from
the body.
C.
6
2
5
1
Assemble the off/on label (1) onto trim ring (2).
Slide trim ring onto sleeve (3) until it bottoms
out on the escutcheon (4). Install handle (5)
onto stem, tighten set screw to secure. Thread
the bonnet assemblies (6) onto the jet sleeve
assemblies (7).
1
3
4
7
6
B.
4
5
3
Thread sleeve (1) onto brass body, use wrench
to tighten. Place escutcheon (2) over jet body
module. Install screws (3). Thread the jet sleeve
assemblies (4) onto the jet body module.
Use the wrench (5) to tighten the sleeve
assemblies. CAUTION: TIGHTEN UNTIL THE
ESCUTCHEON IS FLAT AGAINST THE WALL.
DO NOT OVER TIGHTEN.
12
1
2
Publicité
