Publicité
Les langues disponibles
Les langues disponibles
Jetted Shower XO
A.
1
Turn off water supplies. Remove
plasterguard (1), test caps (2), bonnet nut
and test cap (3) from the body.
C.
1
Thread trim sleeve (1) onto threaded sleeve (2).
Tighten securely with wrench.
Jet Module Cartridge and Trim Installation
®
2
3
2
18 Series Installation - Single Units
B.
2
4
Install cartridge (1) into body (2). Slide
sleeve (3) over cartridge stem and onto body.
Secure with bonnet (4). Ensure bonnet is
tightened securely.
D.
2
3
Place escutcheon (1) over the jet body module.
Thread the jet sleeve assemblies (2) onto the
jet body module. Use wrench (3) to tighten the
sleeve assemblies. CAUTION: TIGHTEN UNTIL
THE ESCUTCHEON IS FLAT AGAINST THE
WALL. DO NOT OVERTIGHTEN.
13
1
3
1
2
2
Publicité
