LAZER MH2 Manuel D'utilisation page 6

BREATH GUARD FITTING
1. Align and press the breath deflector snap into place.
2. Don't carry your helmet by the breath deflector. Otherwise, some parts may be dislocated or broken.
DETACHABLE INNER PARTS
The crown pad, the right and left
cheek pads can be removed for
washing.
You can also adjust the fit of your
helmet by switching to thicker or
thinner pads.
Look at the list and drawing of interior
parts and check whether the parts
are installed or removed.
Be sure to always fix the crown pad,
and the cheek pads prior to riding.
Chin Curtain Crown Pad
Cheek Pad R
Cheek Pad L
- 10 -
HOW TO FIX THE CROWN PAD
1. Make sure that the crown pad is correctly aligned, then at the rear insert the 2 male buttons into the
female buttons.
2. At the front, slide the plastic part of the crown part into the corresponding plastic part on the helmet.
HOW TO REMOVE CROWN PAD
1. At the front, gently pull the plastic parts of the crown pad out.
2. At the rear, unplug the two male buttons.
2
1
1 2
- 11 -