LAZER MH2 Manuel D'utilisation page 5

HOW TO INSTALL THE SHIELD
1
1. Make sure that the visor is in upper position. Pull the wrench down and put the visor into the
holding plates accordingly.
2. Pull the visor down until it stops.
3. Gently press further down until you hear a click that will lock the visor.
HOW TO REMOVE THE SHIELD
1
1. Unclick the visor.
2. Lift it entirely.
3. Pull the wrench down and take the visor out of the holding plates.
CLICK!
2 3
2 3
- 8 -
HOW TO UNINSTALL SUN VISOR
1
1. Lift the chin bar open. Slide the sun visor lever to its rear position (sun visor fully down).
2. Hold the helmet tight and pull the sun visor away from the helmet (pull the left side first, then the right).
3. Once a "click" is audible, the sun visor is released from the helmet.
HOW TO INSTALL SUN VISOR
1 1
1. Lift the chin bar open visor up. Slide the sun visor lever to its rear position
2. Slide the sun visor into the holder on both sides.
3. When a click is audible on both sides, the sun visor is locked.
2 3
CLICK!
2 3
- 9 -